Applied some Neutral Cure Silicone on the jet drive, on the surface between the drive and the interior of the hull, as well as the bottom of the hull (forgot to take photos)
Applied on the surface where the jet propulsion output mounts on the transom as well.
Drilled a hole for cold water intake for the water cooled ESC and brushless motor.
Cut and filed the brass shaft at an angle for more efficient water intake for cooling.
Mounted the shaft onto the jet drive output.
Drilled a hole for the intake hose to go into the boat.
Done!
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.