some updates...
sleeved the links with 8mm heat shrink... i think can use 7mm heat shrinks too...
photo is before heat shrinking...
Enlarge this image Click to see fullsize
found some "materials" to make some dials on the dash....
Enlarge this image Click to see fullsize
and after the dremel-ing.... became these...
Enlarge this image Click to see fullsize
touched up the dials and "installed" them on the dash....
Enlarge this image Click to see fullsize
the M923 has some "handles" all around the truck... one handle on the bonnet, one handle on each side near the door, and one handle on the passenger side dash board...
i made some out of brass rods and brass strip...
after cutting and bending....
Enlarge this image Click to see fullsize
and after some soldering... the handles are done...
Enlarge this image Click to see fullsize
mounted up the axles back onto the chassis...
Enlarge this image Click to see fullsize
primed the handles with grey primer, will be priming the cab and bed again with the grey primer before the final coat of paint....
some photos of the handles mocked up on the different positions...
Enlarge this image Click to see fullsize
Enlarge this image Click to see fullsize
Enlarge this image Click to see fullsize
Enlarge this image Click to see fullsize
thats all for today's midnight oil....
need to top up some oil liao...
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.